DeviceOK
SearchDevice checks
Home / Checks / Audio Production Check
Podcasters, musicians, producers and streamers

Audio Production Check

Verify microphone signal, clipping, monitoring output, and MIDI input before changing DAW routing or audio-interface settings.

Inspection principle

Audio production problems are usually easiest to isolate as input signal → interface/OS device → DAW routing → monitoring output. Verify each boundary in order.

Progress0 of 7 checks recorded
Run next live test ↗

Run the browser-visible checks, then record the physical/native checks below. Progress stays in this browser unless you deliberately copy the fragment share link.

Live evidence

Browser-visible checks

1
Input levelSee a live input level meter and identify audio that is too quiet or clipping.
Run test ↗
2
ClippingDetect repeated peaks that suggest your microphone gain may be too high.
Run test ↗
3
Monitoring channelsPlay left and right channel tones separately.
Run test ↗
4
MIDI inputSee live MIDI note, velocity, control-change, and pitch-bend messages from a connected MIDI input in supported browsers.
Run test ↗
Outside the browser

Physical & native checks

These close the blind spots a website cannot inspect.

1
Interface meters and direct monitoring

If an audio interface is used, compare its hardware input meter/direct-monitor path with DeviceOK and the DAW.

Why it matters: A hardware meter with no browser signal points differently from browser signal with no DAW signal.
2
Sample rate/device mode

Confirm the OS/DAW is using a supported sample-rate/device mode for the interface.

Why it matters: Exclusive-mode or rate conflicts can stop an otherwise healthy interface.
3
Microphone power requirements

Use phantom power only when the microphone/interface documentation calls for it and cabling is appropriate.

Why it matters: Powering rules are hardware-specific and should not be guessed from a browser test.
Stop / escalate

Conditions that deserve caution

  • Damaged XLR/USB/power connectors, electrical noise or overheating.
  • Phantom-power requirements are uncertain for connected equipment.
Decision rule

How to use the evidence

Follow the signal. The first stage where signal disappears is more useful than changing drivers, buffer sizes and cables all at once.

0 passed0 need attention0 skipped